Search found 17 matches

by Mhgjewel
Sun Nov 12, 2017 9:21 pm
Forum: Software
Topic: Contour 1.9.0.0
Replies: 15
Views: 8923

Re: Contour 1.9.0.0

The new upgrade grid calibration is is awesome!!!!
by Mhgjewel
Tue Aug 29, 2017 9:04 pm
Forum: Casting
Topic: tunnel porosity
Replies: 8
Views: 11022

tunnel porosity

im currently using a 50/50 b9 cherry / b9 green mix with premier optima investment. they surface turns out beautiful but on closer inspection there might be a tiny pit and when i go to repair it with the laser it ends up being a tunnel or pocket under the surface. we double vacuum the inside the fla...
by Mhgjewel
Mon Jun 12, 2017 6:56 pm
Forum: General
Topic: the best support
Replies: 1
Views: 1745

the best support

just wanted to shout out to Emil and Mark for getting me through my month of hell. after trouble shooting everything Emil determined that my tilt motor was probably the problem. as soon as i put the new one in and did my first print all has been PERFECT!!!! thank you Emil and Mark as always for your...
by Mhgjewel
Thu May 18, 2017 8:15 pm
Forum: Help and Troubleshooting
Topic: grainy missing parts and heavy build lines
Replies: 3
Views: 2270

Re: grainy missing parts and heavy build lines

hey Mark, thats always a challenge to figure that out. i always tighten the screws until it just feel resistance. whats crazy is every print for months was perfect i didnt even need to think about anything then it all went to shit. im back up to ok with green only but i really like the quality i was...
by Mhgjewel
Thu May 18, 2017 5:07 pm
Forum: Help and Troubleshooting
Topic: grainy missing parts and heavy build lines
Replies: 3
Views: 2270

grainy missing parts and heavy build lines

in the past a scuffed film would cause these grainy missing parts, any other suggestions on a cause? also these heavy build lines at 75% of the build seems to be showing up, any thoughts?
by Mhgjewel
Sat May 06, 2017 6:52 pm
Forum: Resins
Topic: Hybrid Resin Blend (WaxCast and Emerald)
Replies: 57
Views: 52889

Re: Hybrid Resin Blend (WaxCast and Emerald)

Are you getting a glass finish cure all the way to the center? How long are you leaving it under those lights? In or out of water?
by Mhgjewel
Sat May 06, 2017 5:59 pm
Forum: Resins
Topic: Hybrid Resin Blend (WaxCast and Emerald)
Replies: 57
Views: 52889

Re: Hybrid Resin Blend (WaxCast and Emerald)

What are you using?
by Mhgjewel
Sat May 06, 2017 3:42 pm
Forum: Resins
Topic: Hybrid Resin Blend (WaxCast and Emerald)
Replies: 57
Views: 52889

Re: Hybrid Resin Blend (WaxCast and Emerald)

Pics
by Mhgjewel
Sat May 06, 2017 3:40 pm
Forum: Resins
Topic: Hybrid Resin Blend (WaxCast and Emerald)
Replies: 57
Views: 52889

Re: Hybrid Resin Blend (WaxCast and Emerald)

How cured does the hybrid need to befor casting. I've tried leaving the print in my UV for many many hours. but I still have a band of dark running through the model and if I snap it in half it's clearly not fully cured.