Search found 787 matches
Re: InFocus
Call Infocus. 877-388-8360 They list the lamp on their website.
- Thu Nov 28, 2019 4:51 am
- Forum: Help and Troubleshooting
- Topic: Infocus projector settings
- Replies: 4
- Views: 12447
Re: Infocus projector settings
You should have a manual that came with the printer. Best to use it.
- Wed Nov 27, 2019 4:31 am
- Forum: Help and Troubleshooting
- Topic: Problems with the Print
- Replies: 1
- Views: 8490
Re: Problems with the Print
After update did you check the RGB computer display settings. Make sure you check the projector settings. Most times an update reverts the setting back to default. Fairly certain that is your problem.
- Sat Nov 09, 2019 2:37 am
- Forum: Help and Troubleshooting
- Topic: Failed prints: a number of layers FULLY cured
- Replies: 10
- Views: 26745
Re: Failed prints: a number of layers FULLY cured
When checking the setting, be Sure you have selected the projector in the drop down box. Then check the RGB setting
- Tue Nov 05, 2019 4:29 am
- Forum: Help and Troubleshooting
- Topic: Solus3D Home cycle not running
- Replies: 13
- Views: 27983
Re: Solus3D Home cycle not running
First. With it stuck on bottom. Turn power off. Turn the screw so that it goes up and clears the vat. Take off build platform. Turn printer back on. Restart computer. Open contour. Go to setup under File tab. Click on box Go to controller. Run the home command. So you are saying that it will home? T...
- Mon Nov 04, 2019 4:38 am
- Forum: Help and Troubleshooting
- Topic: Solus3D Home cycle not running
- Replies: 13
- Views: 27983
Re: Solus3D Home cycle not running
Are you saying it did the Homing cycle but stopped at the bottom?
Might be a bad switch. Or you got resin down between the plunger and tube and it won't allow it to press the switch.
Might be a bad switch. Or you got resin down between the plunger and tube and it won't allow it to press the switch.
- Fri Sep 27, 2019 3:28 am
- Forum: Help and Troubleshooting
- Topic: Various Grow Line Issues
- Replies: 6
- Views: 14170
Re: Various Grow Line Issues
Glad you got it solved. I had bad prints last week. Settings looked ok but I saw where my laptop had an update. Had to find an update to the update to fix the problem.
- Tue Sep 17, 2019 3:19 am
- Forum: General
- Topic: Calibration Problem
- Replies: 3
- Views: 10579
Re: Calibration Problem
The thinnest would be best. No more than the thickness of the film. DO NOT change the grid layout size. Size it to the print profile you are using. Always use the rectangle grid, just measure it accurately. I don't know much about changing the micron size. You can but you would have to play with the...
- Sun Sep 15, 2019 3:32 am
- Forum: General
- Topic: oval prints , whats the fix again ?
- Replies: 1
- Views: 8541
- Sun Sep 15, 2019 3:26 am
- Forum: Casting
- Topic: tunnel porosity
- Replies: 8
- Views: 25216
Re: tunnel porosity
I just had two rings do this. I had sprus running up to the top of the ring in two places. Was a split shank at top with stones set into it. I figured it was because of the seats Boolean out through the shank. Redesigned ring without, still had tunnels. This was a thicker ring, 3.2mm stones. I cured...