Search found 1900 matches
Re: New Solus
No. This one will only have one set resolution.
Re: New Solus
The accuracy of the Solus Pro and the light source allow for greater detail and smaller minimum feature sizes. Therefore 42um XY resolution is more than enough for fine jewelry. Also the build area is large enough for printing rings or bracelets.
- Mon Sep 16, 2019 10:37 pm
- Forum: News and Announcements
- Topic: Introducing the Solus PRO!
- Replies: 1
- Views: 34232
Re: Introducing the Solus PRO!
Some prints from this machine.
https://vimeo.com/358448351
https://vimeo.com/359910977
https://vimeo.com/351661540
https://vimeo.com/358448351
https://vimeo.com/359910977
https://vimeo.com/351661540
- Wed Aug 28, 2019 4:06 pm
- Forum: Help and Troubleshooting
- Topic: Failed prints: a number of layers FULLY cured
- Replies: 10
- Views: 26884
Re: Failed prints: a number of layers FULLY cured
Check you FULL RGb settings.
- Wed Aug 28, 2019 5:52 am
- Forum: Resins
- Topic: how many people use the B9 resins on the solus ?
- Replies: 22
- Views: 51163
Re: how many people use the B9 resins on the solus ?
Mark, it’s not the b9 resin.
- Tue Aug 27, 2019 7:58 pm
- Forum: Resins
- Topic: how many people use the B9 resins on the solus ?
- Replies: 22
- Views: 51163
Re: how many people use the B9 resins on the solus ?
Lower it by 0.5s to start and yes move the slider to the left by 1 notch.
- Tue Aug 27, 2019 4:21 pm
- Forum: Resins
- Topic: how many people use the B9 resins on the solus ?
- Replies: 22
- Views: 51163
Re: how many people use the B9 resins on the solus ?
so how do I get the new green to print as sharp as the brown did ? all the holes (cut outs ) made for the stones are covered with the prongs of the next stone on top , they blend , what way do I move my settings to compensate , or is this just the way it prints ?? Make sure you're using the correct...
- Fri Aug 23, 2019 1:59 pm
- Forum: Hardware
- Topic: Replacing Arduino Board
- Replies: 1
- Views: 11940
Re: Replacing Arduino Board
Contact your reseller for support with this. No, a plain arduino board won’t work because it doesn’t have the correct firmware.
- Fri Aug 16, 2019 11:28 pm
- Forum: Resins
- Topic: how many people use the B9 resins on the solus ?
- Replies: 22
- Views: 51163
Re: how many people use the B9 resins on the solus ?
1 hour in glycerin under uv lights.
- Fri Aug 16, 2019 2:55 am
- Forum: Resins
- Topic: ResinWorks EasyCastHD castable resin
- Replies: 72
- Views: 159636
Re: ResinWorks EasyCastHD castable resin
Jesse, have you tried bumping up your exposure a bit?