Search found 109 matches
- Fri Dec 25, 2015 2:02 am
- Forum: General
- Topic: when to replace film
- Replies: 6
- Views: 11204
Re: when to replace film
will the stir stick included with the printer damage the film?
- Fri Dec 25, 2015 12:40 am
- Forum: General
- Topic: when to replace film
- Replies: 6
- Views: 11204
Re: when to replace film
what causes the film to wear?
how many prints do you expect to get from one piece of film?
how many prints do you expect to get from one piece of film?
- Thu Dec 24, 2015 5:26 pm
- Forum: General
- Topic: when to replace film
- Replies: 6
- Views: 11204
when to replace film
i had consistent failures of prints, and they were rather strange. one side of the part would come out but then you could see where the other side had stopped. also, the layers on the part were much more apparent. replaced the film, prints look incredible, and no failures. anyway, is there a way to ...
- Mon Dec 21, 2015 11:15 pm
- Forum: Hardware
- Topic: Trapezoid Image Issues on InFocus Projector
- Replies: 21
- Views: 36528
Re: Trapezoid Image Issues on InFocus Projector
when installing the lens holder (with 10x lens), I start at the top then slide the bottom on. I found if I didn't do this, the top wouldn't slide on as far, but then I just noticed today, that the bottom was coming off... furthermore, the weight of the 10x pulls the projectors objective lens angle d...
- Sun Dec 20, 2015 7:57 pm
- Forum: Software
- Topic: CW Crashed Mid Print! Help
- Replies: 20
- Views: 33170
Re: CW Crashed Mid Print! Help
you're right, probably won't need that...
could you explain what these features are in the slice profile?
I've looked for a manual for CW, and couldn't find it on their site.
Lift sequence time
z bottom speed (lift is obvious, I assume this is z down speed)
z retract speed
slide/tilt value
could you explain what these features are in the slice profile?
I've looked for a manual for CW, and couldn't find it on their site.
Lift sequence time
z bottom speed (lift is obvious, I assume this is z down speed)
z retract speed
slide/tilt value
- Sat Dec 19, 2015 5:28 am
- Forum: Hardware
- Topic: Trapezoid Image Issues on InFocus Projector
- Replies: 21
- Views: 36528
Re: Trapezoid Image Issues on InFocus Projector
I had to adjust mine -5, i read some resolution is lost with that adjustment. I tried to tilt the projector (back) but surprisingly did not help trapezoidal issue.
- Thu Dec 17, 2015 7:27 pm
- Forum: Software
- Topic: CW Crashed Mid Print! Help
- Replies: 20
- Views: 33170
Re: CW Crashed Mid Print! Help
Is there a list of all codes and their operation?
$h - home
$x - override home
Etc. ?
$h - home
$x - override home
Etc. ?
- Wed Nov 25, 2015 5:39 pm
- Forum: Resins
- Topic: One ring to rule them all
- Replies: 4
- Views: 11021
Re: One ring to rule them all
What xy was used?
Re: Curing
We recently purchased a solus (can't wait!) But we have cast many models from the solus in b9 cherry. I can't speak to how they were cured, but what I can tell you is burnout is very important. Air flow is important, oxygen is required to properly break down the resin. Also, the resin doesn't break ...