Hi all,
Can anyone suggest anything to get the print to adhere to the build plate. I've been using the Gel from Jordi but have now run out. Surely there must be another way to make the prints stick???
Search found 40 matches
- Thu Mar 14, 2019 12:26 pm
- Forum: Resins
- Topic: Solus Wax not sticking to build plate
- Replies: 4
- Views: 12314
- Thu Nov 22, 2018 11:48 am
- Forum: Help and Troubleshooting
- Topic: Drop in intensity on infocus projector
- Replies: 12
- Views: 20480
Re: Drop in intensity on infocus projector
Just a quick update, I had to purchase a new projector and as the infocus isn't made anymore, I went for a Vivetek 1188. still couldn't get this to print either, even after setting the projector up with the correct settings, so after pulling all my hair out, I tried, on Jordi's advice, to print with...
- Wed Oct 31, 2018 4:22 pm
- Forum: Help and Troubleshooting
- Topic: Drop in intensity on infocus projector
- Replies: 12
- Views: 20480
Drop in intensity on infocus projector
Hello all, Been having problems printing. I've an Infocus 8606HD projector and I've changed the lamp for an original infocus one, I've changed the film on the resin tank, I've changed the tilt motor in the printer, I've gone through the different exposure settings and still my prints are failing. Ma...
- Tue Nov 14, 2017 1:39 pm
- Forum: Help and Troubleshooting
- Topic: prints just started failing
- Replies: 16
- Views: 23770
Re: prints just started failing
I presume so, because I didn't change the settings and I'm sure I have windows updates turned off. Still, at least I'll know what to look for next time it happens.
- Tue Nov 14, 2017 12:54 pm
- Forum: Help and Troubleshooting
- Topic: prints just started failing
- Replies: 16
- Views: 23770
Re: prints just started failing
Finished print. thanks everyone, it seems to be back working as usual again ....I can only think it was the RGB issue.
- Tue Nov 14, 2017 11:26 am
- Forum: Help and Troubleshooting
- Topic: prints just started failing
- Replies: 16
- Views: 23770
Re: prints just started failing
Print is half way through and it all looks good so far, so thanks all for the advice. I presume it was just the RGB issue although I hadn't changed it at all. Will upload pictures when the print completes.
- Mon Nov 13, 2017 3:02 pm
- Forum: Help and Troubleshooting
- Topic: prints just started failing
- Replies: 16
- Views: 23770
Re: prints just started failing
I do indeed . OK, I'll go for another print tomorrow and report back.
- Mon Nov 13, 2017 2:58 pm
- Forum: Help and Troubleshooting
- Topic: prints just started failing
- Replies: 16
- Views: 23770
Re: prints just started failing
i have found my monitor settings and adjusted the quantization range from the default to full range. Would that be it?
- Mon Nov 13, 2017 2:38 pm
- Forum: Help and Troubleshooting
- Topic: prints just started failing
- Replies: 16
- Views: 23770
Re: prints just started failing
Right, I've Intel HD Graphics and following the instructions, I can get up to the select display > general settings part but then my version doesn't have the 'advanced' section.
- Mon Nov 13, 2017 2:17 pm
- Forum: Help and Troubleshooting
- Topic: prints just started failing
- Replies: 16
- Views: 23770
Re: prints just started failing
Do you know how to double check them on windows 10?