Search found 68 matches
- Mon Nov 16, 2015 5:35 pm
- Forum: Help and Troubleshooting
- Topic: Mis prints
- Replies: 51
- Views: 71714
Re: Mis prints
Just for fun try move to different location or print in Z
- Sun Nov 15, 2015 6:48 pm
- Forum: Help and Troubleshooting
- Topic: Mis prints
- Replies: 51
- Views: 71714
Re: Mis prints
No holes, it will print if I print vertically. Just not laying down?? alway in the same place. I may be the film, then I first started I did not set color to full RBG and had window7 Aero on. And have a lot of resin stuck to it. I think I make have dented the film.
- Sun Nov 15, 2015 6:37 pm
- Forum: Tips and Tutorials
- Topic: Procedure or Check List for 25 to 41 and back again.
- Replies: 26
- Views: 44195
Re: Procedure or Check List for 25 to 41 and back again.
I think my grid is not centered
- Sat Nov 14, 2015 8:26 pm
- Forum: Help and Troubleshooting
- Topic: Mis prints
- Replies: 51
- Views: 71714
Re: Mis prints
The failure is always in one place, and when I added a support it started after that.
- Sat Nov 14, 2015 5:55 pm
- Forum: Tips and Tutorials
- Topic: Procedure or Check List for 25 to 41 and back again.
- Replies: 26
- Views: 44195
Re: Procedure or Check List for 25 to 41 and back again.
Can you send me, I have not got anything to print 41. Does the filter need to me back on.
- Fri Nov 13, 2015 7:43 pm
- Forum: Help and Troubleshooting
- Topic: Mis prints
- Replies: 51
- Views: 71714
Re: Mis prints
Ok, after fourth attempt moved it and rotated --success. I guessing there may be a bad spot on the film.
- Fri Nov 13, 2015 1:17 am
- Forum: Help and Troubleshooting
- Topic: Mis prints
- Replies: 51
- Views: 71714
Re: Mis prints
Yes the skull is solid, I'll trying to print the length xy direction to printer faster. The bigger one printed in the Z and that was the first problem I had. The small one was trying to open the mouth in the small one. Also wanted to make sure it not the film
- Thu Nov 12, 2015 8:10 pm
- Forum: Help and Troubleshooting
- Topic: Mis prints
- Replies: 51
- Views: 71714
Mis prints
Getting some incredibly good prints and fabulous details. In my last three prints it starting to miss. The picture with no support I've printer twice before no problems