Search found 157 matches
- Mon Nov 21, 2016 3:56 am
- Forum: Help and Troubleshooting
- Topic: Crystal moving
- Replies: 8
- Views: 12809
Re: Crystal moving
Just tried that same print again with manually placed supports and failed. Not really sure what has happened. A few changes are epoxied the glass. Did Solus updates to .19 Other than that not much. I have been replacing films and did the build table calibration. I took the black shroud off to clean ...
- Mon Nov 21, 2016 12:22 am
- Forum: Help and Troubleshooting
- Topic: Crystal moving
- Replies: 8
- Views: 12809
Re: Crystal moving
I don't know if this is related to my glass moving issue but nothing is printing and I'm eating up films.
Both rings start failing on the same side near the same level.
Both rings start failing on the same side near the same level.
- Sun Nov 20, 2016 1:28 pm
- Forum: Help and Troubleshooting
- Topic: Crystal moving
- Replies: 8
- Views: 12809
Crystal moving
I've been having some failures lately and issues getting my 80x45 grid entirely on the crystal. Yesterday it looked like the plate the crystal is attached to was installed skewed but after a 8hr print failure and then this morning after a 6hr print failure I noticed the crystal had moved. There was ...
- Sat Nov 19, 2016 3:54 pm
- Forum: Resins
- Topic: Proto curing entire build footprint
- Replies: 9
- Views: 15157
Re: Proto curing entire build footprint
Would you choose one over the other for casting or about equal results?
- Sat Nov 19, 2016 2:27 am
- Forum: Gallery
- Topic: Kerstien's Prints
- Replies: 122
- Views: 168361
Re: Kerstien's Prints
Very nice, impressive.
- Fri Nov 18, 2016 2:59 pm
- Forum: Gallery
- Topic: new one for me
- Replies: 3
- Views: 7321
Re: new one for me
I am curious as well. I try to put my makers mark and metal in the prints, using emerald but they never seem to turn out near as well as yours. I'm not sure if I get trapped air during investing, not getting clean burnout, not using the correct mixture ratio, or if investment breaks down during cast...
- Fri Nov 18, 2016 2:52 pm
- Forum: News and Announcements
- Topic: Auto Supports and Manual Supports now in Contour!
- Replies: 69
- Views: 232230
Re: Auto Supports and Manual Supports now in Contour!
My experiences is, it downloaded, installed, and works perfectly.
- Thu Nov 17, 2016 7:26 pm
- Forum: Gallery
- Topic: Prints from Spain
- Replies: 105
- Views: 188027
Re: Prints from Spain
As always, excellent work.
- Thu Nov 17, 2016 7:24 pm
- Forum: News and Announcements
- Topic: Auto Supports and Manual Supports now in Contour!
- Replies: 69
- Views: 232230
Re: Auto Supports and Manual Supports now in Contour!
I can not wait to get the beta version with supports! It's going to save tons of time manually putting in supports, tons of time mulling over questionable support areas and second guessing support locations, save on time used making bad prints due to missed supported areas. Can not wait!
- Thu Nov 17, 2016 12:52 am
- Forum: Resins
- Topic: Formlabs castable
- Replies: 35
- Views: 79311
Re: Formlabs castable
For sure. I'm always near when running those. Been doing that over 2 years, not 1 issue thus far. Knock on flame retardant wood.