Search found 573 matches
- Thu Jan 04, 2018 6:15 pm
- Forum: Software
- Topic: Error Messages
- Replies: 10
- Views: 18026
Re: Error Messages
Bob turn everything off and try it again.
- Sun Dec 24, 2017 2:26 pm
- Forum: General
- Topic: Merry Christmas. Happy New Year
- Replies: 3
- Views: 7943
Re: Merry Christmas. Happy New Year
Back at you! Been super busy here so I havent been posting much. I am going to take a break after today. Wont be back in the shop till Jan 1 2018!! God bless everyone!!
- Fri Dec 01, 2017 4:21 pm
- Forum: Casting
- Topic: tunnel porosity
- Replies: 8
- Views: 25047
Re: tunnel porosity
Whenever you get a thinner area transition into a heavier area( more Mass) this will happen if the part is not sprued properly. Always have your main sprue attached to the heaviest spot on the model. Even with mens rings I design them where the shank has the most mass and the top has the mass spread...
- Wed Nov 08, 2017 2:00 pm
- Forum: Software
- Topic: Contour 1.9.0.0
- Replies: 15
- Views: 25904
Contour 1.9.0.0
I must hand it to the Solus team. The newest version 1.9 is really nice. I and I am sure others really appreciate all the effort. There are definitely some great additions to this version. Thanks guys........................... Mark II
- Thu Nov 02, 2017 5:51 pm
- Forum: Help and Troubleshooting
- Topic: Grid calibration help
- Replies: 21
- Views: 32587
Re: Grid calibration help
Thank you Emil
- Thu Nov 02, 2017 3:48 pm
- Forum: Help and Troubleshooting
- Topic: Grid calibration help
- Replies: 21
- Views: 32587
Re: Grid calibration help
MIne only shows 1.7 available?
- Thu Nov 02, 2017 3:46 pm
- Forum: Help and Troubleshooting
- Topic: Grid calibration help
- Replies: 21
- Views: 32587
Re: Grid calibration help
Nice Emil. I have some downloading to do!! We have released version 1.8 that has the new and improved grid adjustment system. It makes it super easy to make the grid perfect and get rid of all distortion. Simply drag the points and see the grid being adjusted in real-time. It also includes a PDF of ...
- Sun Oct 15, 2017 1:58 am
- Forum: Casting
- Topic: Optima investment - viscosity
- Replies: 6
- Views: 13527
Re: Optima investment - viscosity
I have been using 36 to 100 with the.optima.
- Sat Oct 14, 2017 6:30 pm
- Forum: Help and Troubleshooting
- Topic: Teardrop pendant warped
- Replies: 5
- Views: 10220
Re: Teardrop pendant warped
If you are going to print it on its side like that use a .5mm thick fin support the length of all the support you have now. It is very easy the clean up after you print and you wont have any sagging.
- Fri Oct 13, 2017 1:54 am
- Forum: Software
- Topic: Space Navigator
- Replies: 2
- Views: 6734
Space Navigator
Anyone using a Space navigator with Rhino or RhinoGold. If so what doyou think about it.