REINSTALL WINDOWS

This section will include any new tips and tutorials related to the Solus.
Alexpolo
Novice
Posts:14
Joined:Sun Nov 22, 2015 9:21 am
REINSTALL WINDOWS

Postby Alexpolo » Thu Feb 08, 2018 8:47 am

HI All, After running the solus for nearly 2 years swapped to new control computer old one dying looking for current setup instructions running Contour with Vivitech and NVDIA graphics card.
Found this link
https://reify3d.wistia.com/projects/ztww6a0tqj
Missing all the RGB setup and other install info that I vaguely remember.
A pointer to current install procedure would be appreciated.
thanks
User avatar
reify
Site Admin
Posts:571
Joined:Mon Mar 16, 2015 6:10 pm

Re: REINSTALL WINDOWS

Postby reify » Thu Feb 08, 2018 2:15 pm

HI,

I'll email you the manual now.
Alexpolo
Novice
Posts:14
Joined:Sun Nov 22, 2015 9:21 am

Re: REINSTALL WINDOWS

Postby Alexpolo » Thu Feb 08, 2018 10:25 pm

Hi Mark,
Havent received the new document - I found my install instructions but they where for win8 and CW. I have installed ARDUINO 1.68 seems current is 1.85 I have done the RGB full install - in contour I can connect to Solus but wont run home cycle.

Do I need to still install CW? havent used since moving to Contour.
User avatar
Jewelermdt
Solus Master
Posts:809
Joined:Sun Jul 19, 2015 10:38 pm
Location:N.W. Florida
Contact:

Re: REINSTALL WINDOWS

Postby Jewelermdt » Fri Feb 09, 2018 3:50 am

can you raise and lower Z? If not might be the cable. Try different port. In device manager make sure it's turn on and power set to never go idle. Reinstall might have changed these settings. You don't need CW if you have Contour.

Who is online

Users browsing this forum: No registered users and 3 guests