How to support this ring?
Hello everyone I have problem how to suport this ring for printing. For all help thank you!
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: How to support this ring?
What resin are you using? You will need to support ALL prongs that face at a downward angle and perpendicular to the base. Might be better to angle the ring in Y about 15 degrees. If your using Contour see what it put in for support. You may have to add a few where it misses.
Who is online
Users browsing this forum: No registered users and 7 guests