Page 1 of 1

How to support this ring?

Posted: Mon Nov 19, 2018 5:52 am
by Jubiler
Hello everyone I have problem how to suport this ring for printing. For all help thank you!

Re: How to support this ring?

Posted: Tue Nov 20, 2018 1:56 am
by Jewelermdt
What resin are you using? You will need to support ALL prongs that face at a downward angle and perpendicular to the base. Might be better to angle the ring in Y about 15 degrees. If your using Contour see what it put in for support. You may have to add a few where it misses.