Any tips to avoid warping of thin prints?
I've had some warping of thin prints or sections of prints during the curing process and wonder if it's down to curing too rapidly or unevenly- anyone dealt with / resolved this issue before?
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Any tips to avoid warping of thin prints?
Yes. Probably your light is too strong. Try to put the parts further away and rotate them often to cure all sides evenly. A small turn table is a good idea too.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Any tips to avoid warping of thin prints?
I cure my parts in UV while submerged in H2O for about 30 min. Keeping them in water while post curing seems to help reduce warping, but if you leave them in too long (like overnight) the resin begins to adsorb the water and then you get really bad warping.
- M-Williams
- Solus Master
- Posts:393
- Joined:Sun Nov 01, 2015 4:45 pm
Re: Any tips to avoid warping of thin prints?
What resin are you using?. I use cherry , green and I have never experienced such a thing. I rarely submerged them though.
Re: Any tips to avoid warping of thin prints?
I have only used the solus proto resin up to this point.
Who is online
Users browsing this forum: No registered users and 72 guests