SolusArt print failure

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
rrobbie
Posts: 5
Joined: Mon Aug 12, 2019 1:12 pm

SolusArt print failure

Postby rrobbie » Wed Oct 09, 2019 1:30 pm

Hello,

If somebody have an experience with SolusArt Grey resin, would you be so kind to help me?
This is the first day I am trying to print this type of material and all of the prints have fallen down from the build platform with the basic settings.
Is there any special setting for that resin?

I used SolusProto without any mistake.

Thanks in advance!

Best regards,

Robert
User avatar
mongerdesigns
Solus Guru
Posts: 1904
Joined: Sat Apr 25, 2015 5:16 pm
Location: Los Angeles
Contact:

Re: SolusArt print failure

Postby mongerdesigns » Wed Oct 09, 2019 7:41 pm

Yes, there is a profile in contour.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Follow us on Instagram!
https://www.instagram.com/junction3d/
User avatar
exedebee
Solus Expert
Posts: 126
Joined: Fri Feb 12, 2016 3:39 am

Re: SolusArt print failure

Postby exedebee » Thu Oct 10, 2019 1:38 am

Try increasing exposure time 0.5s
rrobbie
Posts: 5
Joined: Mon Aug 12, 2019 1:12 pm

Re: SolusArt print failure

Postby rrobbie » Thu Oct 10, 2019 11:44 am

mongerdesigns wrote:Yes, there is a profile in contour.


Ok, thanks, I know, I tried with that. And it doesn't work for me at all.
But alread have spoken to Jordi, who helped me...

Who is online

Users browsing this forum: No registered users and 7 guests