Warped Prints

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
Posts: 35
Joined: Wed Oct 24, 2018 9:55 pm

Re: Warped Prints

Postby emild » Sat Nov 23, 2019 10:36 pm

hasd81 wrote:I’m getting the same thing with my prints, same height every time.

Anyone solved this ????
Posts: 24
Joined: Sat Dec 29, 2018 10:38 am

Re: Warped Prints

Postby Kokos » Mon Nov 25, 2019 6:02 pm

If it is not your support or your film not being flat. You can also try and mount the Z-axis screw upside down. Then if it would have a bad spot it would be in a different location. Unless it is exactly in the middle.
Posts: 2
Joined: Fri Jan 12, 2018 9:26 pm

Re: Warped Prints

Postby icibis » Fri Oct 02, 2020 5:41 pm

Did you ever figure out a fix for this? I have the same issue, but only with castable resins (emerald and soluscast). Art grey and solusproto work fine.

Who is online

Users browsing this forum: No registered users and 15 guests