Stretched Z-axis

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
Post Reply
ThijsdeBruijn
Novice
Posts:17
Joined:Tue Apr 26, 2016 5:14 pm
Contact:
Contact ThijsdeBruijn
Stretched Z-axis

Postby ThijsdeBruijn » Sun May 29, 2016 5:48 pm

Hey guys,

I've noticed in my prints that it's elongated on the Z-axis. First I thought it was because of lack of supports but I also have it with prints that are well supported. Which settings should I change to compensate for this?

Thijs
Top
User avatar
reify
Site Admin
Posts:571
Joined:Mon Mar 16, 2015 6:10 pm

Re: Stretched Z-axis

Postby reify » Sun May 29, 2016 8:29 pm

This would be very unusual...are you sure your XY build area is calibrated correctly?
Top
ThijsdeBruijn
Novice
Posts:17
Joined:Tue Apr 26, 2016 5:14 pm
Contact:
Contact ThijsdeBruijn

Re: Stretched Z-axis

Postby ThijsdeBruijn » Sun May 29, 2016 8:51 pm

Yeah I'm sure. Keep in mind that I've had other 3d printers connected to CW. Maybe some left-over settings?
Top
User avatar
reify
Site Admin
Posts:571
Joined:Mon Mar 16, 2015 6:10 pm

Re: Stretched Z-axis

Postby reify » Mon May 30, 2016 2:28 am

I guess it's possible it could have corrupted the firmware settings. I'll contact you to check your settings.
Top
Post Reply

Return to “Help and Troubleshooting”

Who is online

Users browsing this forum: No registered users and 5 guests