layer failures

[Christian K.]

Since 1 week our solus makes everythime at layer 407 these shifted layers.. i don't know what to do ....

Our solus had no problems since 3 months.. and now everytime..

Best regards!

[mongerdesigns]

Clean the lead screw with a paper towel and some alcohol and then apply some fresh grease. Then run the arm up and down a few times to lubricate. Most likely some dirt is packed into the thread at that location and is causing a shift when moving through.

[Christian K.]

Sadly it didn't help. everytime at the same layers. is it possible, that there is something in te slus that causes this error ?

Its really a problem.. we need our solus every day - is there a possability to get helped in Austria?
Bought the solus frm Spain

Best regards ! and thank you

[reify]

Hi,

Do you mean here?

Shift.jpg (39.98KiB)Viewed 14327 times

Do you have any other examples? It's hard to see what's happening in this one.

[Christian K.]

Yes exactly!

There are 2 layers that making problems.. but why?.


On the foto you cannot see it perfectly:

Where you mae the jellow circle is the layer not shifted to the right or the left - you see it when you look from the side on the model - i will upload some more photos tomorrow.

we tried different models.. but without success. Alwasy the same layers!

Thank you very much !!

[Christian K.]

Here is the photo..
every print everytiem the same thing.

layer 406 and layer 423...

Thank you very much in advance !

[reify]

Please email me at reify3d@gmail.com when you're free and I'll take a look at a couple of your computer settings.

[Christian K.]

So - we resetted everything, now it seems, that solved the problem!!!

Maybe any bug, that causes this problem.
Thank you for your help. tomorrow i will see if everything is fine

[Christian K.]

Ah... came again

[Jewelermdt]

I believe he meant Re-set all the settings.