Hello, still there is a line
-
- Solus Expert
- Posts:197
- Joined:Wed Feb 17, 2016 10:36 pm
Check all the glass window too. Make sure they are clean and clear. You should try with Emerald original exposure of 4.5 seconds instead of 4.35 seconds you have there to test for problem.
Re: Hello, still there is a line
reify wrote:Hi,
I have just emailed you a ring stl to test. Where are you located?
Thank you, Mark.
I printed test file you gave me.
And the result is just fine. Like that pieces are used to be fine.
And I am living NJ
Re: Hello, still there is a line
reify wrote:Hi,
I have just emailed you a ring stl to test. Where are you located?
Thank you, Mark.
I printed the ring you gave me.
And the result is just fine. Like that pieces are fine.
I am living NJ.
Thank you
Re: Hello, still there is a line
For that large ring you may want to try simply tilting it at 15 - 20 degrees and then printing. That would create a gradual build up to the large section instead of the sudden large layer slice that can slide around. If you still have the line at that same area after trying that, try cleaning and re-lubing the Z-screw.
Who is online
Users browsing this forum: No registered users and 6 guests