Page 1 of 2

Solus3D Home cycle not running

Posted: Wed Oct 25, 2017 4:58 am
by KentaTakashi
I have tried the unplug -replug method. ( but it is wildly inconsistent) with this time not working at all

I have tried replacing the cable as suggested by support also no help.


I need this to consistently work without it failing every time i try to run a print

Any help and suggestions anyone figure out a permanent solution. Any software solutions for Reify?

Re: Solus3D Home cycle not running

Posted: Wed Oct 25, 2017 6:37 am
by mongerdesigns
Kevin,

Email me tomorrow morning and I can connect and test it. We’ll get it fixed for you. Info@junction3d.com

Re: Solus3D Home cycle not running

Posted: Wed Oct 25, 2017 6:44 am
by reify
Any chance you're using a USB hub? Have you tried a different USB port on your computer?

Re: Solus3D Home cycle not running

Posted: Thu Oct 26, 2017 3:36 am
by Jewelermdt
In your Device Manager for the computer, check the properties for the USB's. They should be set to Always on. Don't let them go idle if unused. If using a laptop, power set to full, never sleep, no screen-savers, no hibernate.

Re: Solus3D Home cycle not running

Posted: Sun Nov 03, 2019 4:15 pm
by kolovos700
Hello,
My solus has stuck at the bottom after power off, it doesn't do anything
I have tried everthing i have read in the forum but not change.
Any help will be appreciated.

Re: Solus3D Home cycle not running

Posted: Mon Nov 04, 2019 4:38 am
by Jewelermdt
Are you saying it did the Homing cycle but stopped at the bottom?

Might be a bad switch. Or you got resin down between the plunger and tube and it won't allow it to press the switch.

Re: Solus3D Home cycle not running

Posted: Mon Nov 04, 2019 8:47 am
by kolovos700
yes i thing is switch .What you recommend me to do.

Re: Solus3D Home cycle not running

Posted: Mon Nov 04, 2019 5:05 pm
by kolovos700
Hi,
The switcher work fine.
after the build platform hit it is stops and doesn't go up.

Re: Solus3D Home cycle not running

Posted: Tue Nov 05, 2019 4:29 am
by Jewelermdt
First. With it stuck on bottom. Turn power off. Turn the screw so that it goes up and clears the vat. Take off build platform. Turn printer back on. Restart computer. Open contour. Go to setup under File tab. Click on box Go to controller. Run the home command.

So you are saying that it will home? That it will go down, hit the button and go back up? But when you put the platform on and try to print it goes down and stops?

Re: Solus3D Home cycle not running

Posted: Tue Nov 05, 2019 6:41 am
by kolovos700
Hi,
I have done the above recommendations the printer goes down hits the switcher and stays there (is not going up and the homing process never finishes).
The switcher works fine.