Page 1 of 1
printer stuck during Homing circle
Posted: Thu Nov 09, 2017 2:15 am
by CHAMAL
My printer during Homing circle once it's going down it stuck and. Some sound comes it's not going up. Why is that. I just tryed switch off and removed the divides and re connect. But the same why is that
Re: printer stuck during Homing circle
Posted: Thu Nov 09, 2017 4:38 am
by Jewelermdt
Sometimes I do a home with the vat still on printer. If it's too tight I will get a noise and it will stay down till I loosen the vat screws. So my guess would be the quartz is stuck, or a broken switch (BTDT) or as I just posted the other day, resin cure inside the tube of the homing pin.
Re: printer stuck during Homing circle
Posted: Thu Nov 09, 2017 5:43 am
by Waever
You use contour?
Try homing on CWS
Re: printer stuck during Homing circle
Posted: Thu Nov 09, 2017 6:18 am
by CHAMAL
solve it! i just pressed the reset button .