printer stuck during Homing circle

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
User avatar
CHAMAL
Novice
Posts:52
Joined:Fri Mar 31, 2017 12:45 pm
Location:srilanka
Contact:
printer stuck during Homing circle

Postby CHAMAL » Thu Nov 09, 2017 2:15 am

My printer during Homing circle once it's going down it stuck and. Some sound comes it's not going up. Why is that. I just tryed switch off and removed the divides and re connect. But the same why is that
W.A Chamal .S .Jayaratna
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com
User avatar
Jewelermdt
Solus Master
Posts:809
Joined:Sun Jul 19, 2015 10:38 pm
Location:N.W. Florida
Contact:

Re: printer stuck during Homing circle

Postby Jewelermdt » Thu Nov 09, 2017 4:38 am

Sometimes I do a home with the vat still on printer. If it's too tight I will get a noise and it will stay down till I loosen the vat screws. So my guess would be the quartz is stuck, or a broken switch (BTDT) or as I just posted the other day, resin cure inside the tube of the homing pin.
Waever
Novice
Posts:83
Joined:Sat Apr 23, 2016 10:34 am

Re: printer stuck during Homing circle

Postby Waever » Thu Nov 09, 2017 5:43 am

You use contour?
Try homing on CWS
User avatar
CHAMAL
Novice
Posts:52
Joined:Fri Mar 31, 2017 12:45 pm
Location:srilanka
Contact:

Re: printer stuck during Homing circle

Postby CHAMAL » Thu Nov 09, 2017 6:18 am

solve it! i just pressed the reset button .
W.A Chamal .S .Jayaratna
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com

Who is online

Users browsing this forum: No registered users and 12 guests