tilt plate gap
Should there be a gap on the left side between tilt plate and top surface? On the right side, it's flush, but on left there is slight gap. I'm not sure if it has always been there. I'm suddenly having problems getting attachment to build plate so looking it over.
- Attachments
-
- solusgap.jpg (140.5KiB)Viewed 5791 times
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: tilt plate gap
There could be a small gap. Around 1mm or so.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: tilt plate gap
Re-calibrate the build plate to the table. Things can move.
Who is online
Users browsing this forum: No registered users and 5 guests