tilt plate gap

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
Post Reply
Biceps
Novice
Posts:46
Joined:Wed Dec 30, 2015 8:25 am
tilt plate gap

Postby Biceps » Sat Feb 03, 2018 12:34 am

Should there be a gap on the left side between tilt plate and top surface? On the right side, it's flush, but on left there is slight gap. I'm not sure if it has always been there. I'm suddenly having problems getting attachment to build plate so looking it over.
Attachments
solusgap.jpg
solusgap.jpg (140.5KiB)Viewed 5768 times
Top
User avatar
mongerdesigns
Solus Guru
Posts:1950
Joined:Sat Apr 25, 2015 5:16 pm
Location:Los Angeles
Contact:
Contact mongerdesigns

Re: tilt plate gap

Postby mongerdesigns » Sat Feb 03, 2018 1:47 am

There could be a small gap. Around 1mm or so.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Follow us on Instagram!
https://www.instagram.com/junction3d/
Top
User avatar
Jewelermdt
Solus Master
Posts:809
Joined:Sun Jul 19, 2015 10:38 pm
Location:N.W. Florida
Contact:
Contact Jewelermdt

Re: tilt plate gap

Postby Jewelermdt » Sat Feb 03, 2018 4:15 am

Re-calibrate the build plate to the table. Things can move.
Top
Post Reply

Return to “Help and Troubleshooting”

Who is online

Users browsing this forum: No registered users and 72 guests