30 -Reify3D Forum

EddyF · Postby **EddyF** » Sun Dec 27, 2015 2:28 am

I have not been able to print at 42xy, so today I tried the 30z mic and after about 3 min the projector was not light up, the printer was moved, but the projector did not light. I tried 25z and the projector work,but still failing at the supports. Any ideals

KBS756 · Postby **KBS756** » Sun Dec 27, 2015 4:52 am

EddyF wrote:I have not been able to print at 42xy, so today I tried the 30z mic and after about 3 min the projector was not light up, the printer was moved, but the projector did not light. I tried 25z and the projector work,but still failing at the supports. Any ideals

I had failing at supports before it was because 1 side of my VAT film was too tight

Postby **mongerdesigns** » Sun Dec 27, 2015 5:43 am

Also make sure to check the calibration of the build table.

Archerm · Postby **Archerm** » Sun Dec 27, 2015 5:59 pm

Hey guys something I learned the hard way with the infocus projector. I know it is something simple. I moved mine the second day I set everything up and had a few failures after the move. Make sure the plug is pushed all the way in in the back of the projector. It goes in a long way. It will work sometime if it is in half way and then you will get a failure. Double check that the plug is pushed all the way in. Zero failures here after I seated the plug in the back of the projector. Mark

30

Re: 30

Re: 30

Re: 30

Who is online