30
I have not been able to print at 42xy, so today I tried the 30z mic and after about 3 min the projector was not light up, the printer was moved, but the projector did not light. I tried 25z and the projector work,but still failing at the supports. Any ideals
Re: 30
EddyF wrote:I have not been able to print at 42xy, so today I tried the 30z mic and after about 3 min the projector was not light up, the printer was moved, but the projector did not light. I tried 25z and the projector work,but still failing at the supports. Any ideals
I had failing at supports before it was because 1 side of my VAT film was too tight
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: 30
Also make sure to check the calibration of the build table.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: 30
Hey guys something I learned the hard way with the infocus projector. I know it is something simple. I moved mine the second day I set everything up and had a few failures after the move. Make sure the plug is pushed all the way in in the back of the projector. It goes in a long way. It will work sometime if it is in half way and then you will get a failure. Double check that the plug is pushed all the way in. Zero failures here after I seated the plug in the back of the projector. Mark
Who is online
Users browsing this forum: No registered users and 7 guests