Hello,
Did anyone else have this problem? Prints fail after completing supports, didn't have a single good one. Resin well mixed, film is clean, supports are enough, exposure is increased from 3.7 to 3.9, it just doesn't print further and cures it on the film. Need help
Prints fail after printing supports
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Prints fail after printing supports
How thick are your support tips? Use thicker ones. Also increase the exposure to 4.3 and try again.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
-
- Novice
- Posts:96
- Joined:Mon Mar 28, 2016 8:05 am
Re: Prints fail after printing supports
Hello Margo. Looks like the exposure is still not enough. I m sorry you are getting trouble with it. Please ingress the exposure to 4.3 seconds, this way those supports won't break.
Re: Prints fail after printing supports
I see two things , thicker tips and do manual support base
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Prints fail after printing supports
Yes Bigger tip size will fix it.
Who is online
Users browsing this forum: No registered users and 88 guests