Prints fail after printing supports

[MargoArgo]

Hello,

Did anyone else have this problem? Prints fail after completing supports, didn't have a single good one. Resin well mixed, film is clean, supports are enough, exposure is increased from 3.7 to 3.9, it just doesn't print further and cures it on the film. Need help

[mongerdesigns]

How thick are your support tips? Use thicker ones. Also increase the exposure to 4.3 and try again.

[studiojoia]

Hello Margo. Looks like the exposure is still not enough. I m sorry you are getting trouble with it. Please ingress the exposure to 4.3 seconds, this way those supports won't break.

[rsaldivar]

I see two things , thicker tips and do manual support base

[Jewelermdt]

Yes Bigger tip size will fix it.