Page 1 of 1
Bad prints
Posted: Sun Jun 10, 2018 11:41 pm
by Coreygulerian
Hi
I have been getting these kind of prints all weekend not sure what I need to do to fix or doing wrong please help
Re: Bad prints
Posted: Sun Jun 10, 2018 11:55 pm
by mongerdesigns
Check your graphics cards rgb settings. It’s in the setup instructions.
Re: Bad prints
Posted: Mon Jun 11, 2018 1:44 am
by Jewelermdt
You also have that platform too crowded. Support won't print if they are off the grid. Make sure all parts are at least one square inside of the grid for the support base.
As Emil said and did you calibrate the build platform to the quartz table?
Re: Bad prints
Posted: Mon Jun 11, 2018 1:36 pm
by lklutts
WIndows updates have been changing RGB settings on computers. Also run them through netfab. I have had models run twice through mesh repair and it didnt work. Netfabb fixedd it. Len
Re: Bad prints
Posted: Tue Jun 12, 2018 2:27 am
by robin
Wear gloves!
Re: Bad prints
Posted: Tue Jun 12, 2018 3:54 pm
by rsaldivar
not clear from pic , but cant those be printed flat with no supports ??
Re: Bad prints
Posted: Wed Jun 13, 2018 1:53 am
by exedebee
I think Full RGB issue.
Re: Bad prints
Posted: Wed Jul 25, 2018 7:04 pm
by hx19035
robin wrote:Wear gloves!
Yes. THAT!