Scale adjustments
When you use the scale adjustment utility, is it a global machine calibration or does it need to be redone for each separate material and X-Y configuration?
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Scale adjustments
Yes, you should redo it for each material and XY configuration.
However, most acrylate-based materials should have about the same amount of shrinkage, so the difference will very small.
However, most acrylate-based materials should have about the same amount of shrinkage, so the difference will very small.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 4 guests