slightly skewd prints

[Devlin]

Once in a while I get a completed print that is skewed to one side.
I often reprint in a new position or with more supports. And it may solve the problem.

The skew is usually in the side view on not in the through the finger hole view.

I just did one signet style were the top should be round and it is slight oval in the top down view.

I have been printing in 25xy 25z emerald resin. the prints in general have been amazing!

The bottle of resin is at the end And I am starting a new bottle soon.

I am looking for suggestions to solve the issue.

Thank you

[mongerdesigns]

Post a photo of the print and also of the scene.

[Devlin]

Here are some images of some failed prints, In general do not save the scene on every print.

I will next time to see if it happens.
I usually print looking through the finger hole view, I do have this happen more in the other direction, not sure why that is.

thank you!

[mongerdesigns]

I’ve only seen this being caused by overstretched film. The solution was to replace the film.

[Devlin]

I will try that , thank you!