Problems continue!!!!!! :(

[Sagariz]

I`m still have the problems with my solus and I don`t know what to do

I have this problems :



Tell me could be my laptop so I get a New one and made all the configuration process

Now this are the results



Same problem, so now made build plate calibration and this is the result:




Maybe could be the HDMI cable, so I tray with another one, this are the results.



I get a new resine and this are the resuts.



( the last prints is just 10-15 layers to see if the problem persist)

I`m still have the same problem!!!!! And is not the RGB or the projector settings

Some one could know what would be the problem? I made all the steps maybe 20 times, I bought a new laptop, I`m kind of deseperate with this

I really really appreciate for your help!

[mongerdesigns]

Try lowering your bottom exposure times slowly until the flashing goes away but the prints still stick to the build plate.