I`m still have the problems with my solus and I don`t know what to do
I have this problems :
Tell me could be my laptop so I get a New one and made all the configuration process
Now this are the results
Same problem, so now made build plate calibration and this is the result:
Maybe could be the HDMI cable, so I tray with another one, this are the results.
I get a new resine and this are the resuts.
( the last prints is just 10-15 layers to see if the problem persist)
I`m still have the same problem!!!!! And is not the RGB or the projector settings
Some one could know what would be the problem? I made all the steps maybe 20 times, I bought a new laptop, I`m kind of deseperate with this
I really really appreciate for your help!
Problems continue!!!!!! :(
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Problems continue!!!!!! :(
Try lowering your bottom exposure times slowly until the flashing goes away but the prints still stick to the build plate.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 91 guests