Just put in a new lamp. Once you get to "see manual" it say to press the Up Down buttons in sequence. I've tried every way, does not reset. Does it matter which buttons you press first? Also odd that I had to go and set up the projector setting from scratch. Can't believe replacing the lamp would cause that. I have not been able to get a good print. I got about 3/4 of two rings. Tried a cross today, got the bottom support layer, no supports, and a floating couple layer cross.
Getting back up on work now. ARgggg
Reset lamp hours
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Reset lamp hours
I have the infocus in8606 projector
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Reset lamp hours
I think the sequence matters.
Did you get the bulb directly from Infocus? Which resin are you using?
Did you get the bulb directly from Infocus? Which resin are you using?
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Reset lamp hours
I got it through amazon which was from Infocus. Cause on Infocus website they were out. Go figure. I am using the new solus wax.
I did finally find the sequence to follow. Very busy in store today and did not have a chance to try it. And in leaving tonight and shutting down the computer, it said shut down and update. Crazy you set everything so it won't update and Microsoft finds a way to screw you up anyway. Will see if anything got changed tomorrow.
I did finally find the sequence to follow. Very busy in store today and did not have a chance to try it. And in leaving tonight and shutting down the computer, it said shut down and update. Crazy you set everything so it won't update and Microsoft finds a way to screw you up anyway. Will see if anything got changed tomorrow.
- M-Williams
- Solus Master
- Posts:393
- Joined:Sun Nov 01, 2015 4:45 pm
Re: Reset lamp hours
Our dedicated laptop is not connected to the internet. Never had any issue with random updates. Marc.
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Reset lamp hours
I use dropbox to post my stl files. I do my design work at home and print at the store. Would forget the usb drive, plus all ports are used by printer and projector. Usually I'll just reset computer to previous day.
Who is online
Users browsing this forum: No registered users and 9 guests