Page 1 of 4
Print fails
Posted: Tue Oct 16, 2018 3:34 am
by hasd81
Hey there,
Just looking for some input I keep getting print fails with b9 green. Any help would help.
Re: Print fails
Posted: Tue Oct 16, 2018 5:30 am
by mongerdesigns
Email me your scene file with supports. This looks like a supports issue.
Info@junction3d.com
Re: Print fails
Posted: Tue Oct 16, 2018 11:20 am
by exedebee
I saw some flashing. can you check Full RGB on graphic card .
Re: Print fails
Posted: Wed Oct 17, 2018 6:13 am
by hasd81
mongerdesigns wrote:Email me your scene file with supports. This looks like a supports issue.
Info@junction3d.com
Hey there.
Did you receive my email?
Re: Print fails
Posted: Wed Oct 17, 2018 5:13 pm
by mongerdesigns
Sorry, no.
Maybe put a dropbox link here?
Re: Print fails
Posted: Wed Oct 17, 2018 10:06 pm
by hasd81
exedebee wrote:I saw some flashing. can you check Full RGB on graphic card .
where do i find these settings?
Re: Print fails
Posted: Thu Oct 18, 2018 2:13 am
by Jewelermdt
Right click on your desktop. Graphic Card properties. Depends on what graphics card you have. Look at your manual for setup. It's explained
Re: Print fails
Posted: Thu Oct 18, 2018 2:44 am
by hasd81
Jewelermdt wrote:Right click on your desktop. Graphic Card properties. Depends on what graphics card you have. Look at your manual for setup. It's explained
It goes to the intel graphics and media control panel. its not like it shows in the manual
Re: Print fails
Posted: Thu Oct 18, 2018 3:54 am
by mongerdesigns
How is it then? Post a photo.
Re: Print fails
Posted: Thu Oct 18, 2018 4:02 am
by hasd81