Hey all,
It's been a while since I've used my Solus printer. I opened up Contour today and updated it. I then imported an STL file and noticed some odd geometry that isn't apparent/present on the ring in Matrix. I imported a different ring and the same thing was happening. It never used to do this so I figured I'd bring it up here.
Thanks for any help and suggestions!
Jagged Geometry In Contour
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Jagged Geometry In Contour
Stl export parameters issue from Matrix. You need to adjust the tolerances.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Jagged Geometry In Contour
Thanks for the reply. Honestly, I'm unfamiliar with adjusting Matrix settings/tolerances. Is there a specific tolerance I need to adjust? Is there a specific value I should set? And are these tolerances adjusted as I'm saving the file as an STL in Matrix?
Thanks again!
Thanks again!
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Jagged Geometry In Contour
When you export STL, it gives you a little dialog box before saving with lots of detail fields. There is a button on the bottom right 'SIMPLE CONTROLS'. Press that. Then you will only have one text filed called Tolerance. The default is usually 0.1, which is what you probably used. For smooth detail, use at least 0.01. If you want very smooth, use a smaller number like 0.005 or 0.001, but it's probably overkill and will generate a much larger file.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Jagged Geometry In Contour
I appreciate the help! Using a value of 0.005 made the model acceptably smooth. For some reason, Matrix was defaulting with a value of 0.0.
Who is online
Users browsing this forum: No registered users and 87 guests