Page 1 of 1
Can not do homing after changing film
Posted: Tue Nov 06, 2018 5:59 pm
by petertruong07
Hi,
My printer doesn’t do homing after I changed the film. Any help is appreciated
Peter
Re: Can not do homing after changing film
Posted: Tue Nov 06, 2018 7:41 pm
by mongerdesigns
Peter, just replied to your email.
Re: Can not do homing after changing film
Posted: Tue Nov 06, 2018 8:42 pm
by petertruong07
Emil
Thank you
I think the cable is loose
Re: Can not do homing after changing film
Posted: Fri Nov 30, 2018 10:34 am
by OpedHead
Reset button on the back!
I was in the same sitch once and tried resetting the computer, turning the printer and projector off and on with no result, reset button on the back of the printer was the savior. Also the printer power cable can get loose, not sure what your US plugs are like but we bend our wall plug pins toward each other to make them stay in better sometimes
