Failed Proto Resin after bulb change

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
Post Reply
User avatar
mongerdesigns
Solus Guru
Posts:1950
Joined:Sat Apr 25, 2015 5:16 pm
Location:Los Angeles
Contact:
Contact mongerdesigns
Re: Failed Proto Resin after bulb change

Postby mongerdesigns » Fri Dec 28, 2018 10:57 pm

Yes. When you first bought the projector, you removed the filter from the lamp. The little square piece of glass in the front of the lamp.

New lamps will have the same filter on them. You need to remove them.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Follow us on Instagram!
https://www.instagram.com/junction3d/
Top
Post Reply

Return to “Help and Troubleshooting”

Who is online

Users browsing this forum: No registered users and 9 guests