Hello! No idea why print fail. Any suggestions?
Thank you
Print fail?
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Print fail?
Increase your exposure time and check your supports.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Print fail?
Thank You! How much I should increase exposure?
Re: Print fail?
The end tip of suports for emerald resin should be flat or round?
I'm doing supports in rhinogold.
I'm doing supports in rhinogold.
Re: Print fail?
Are you checking your Rhino support structures in Netfabb? When I was making most of my supports in Matrix it always surprised me how many had issues, even when they checked out as being valid and closed within Matrix. Lost quite a few prints that way before I started using Netfabb.
Also, as Mongerdesigns said, check the location of your supports. One of those rings looks to have claw settings that extend right down the shank to a point that might generate overhangs when printed in that orientation.
Also, as Mongerdesigns said, check the location of your supports. One of those rings looks to have claw settings that extend right down the shank to a point that might generate overhangs when printed in that orientation.
Who is online
Users browsing this forum: No registered users and 4 guests