Page 1 of 1
Print fail?
Posted: Tue Jan 22, 2019 6:16 pm
by Jubiler
Hello! No idea why print fail. Any suggestions?
Thank you
Re: Print fail?
Posted: Tue Jan 22, 2019 7:50 pm
by mongerdesigns
Increase your exposure time and check your supports.
Re: Print fail?
Posted: Tue Jan 22, 2019 7:57 pm
by Jubiler
Thank You! How much I should increase exposure?
Re: Print fail?
Posted: Tue Jan 22, 2019 8:03 pm
by Jubiler
The end tip of suports for emerald resin should be flat or round?
I'm doing supports in rhinogold.
Re: Print fail?
Posted: Tue Jan 22, 2019 11:11 pm
by GSJ_NZ
Are you checking your Rhino support structures in Netfabb? When I was making most of my supports in Matrix it always surprised me how many had issues, even when they checked out as being valid and closed within Matrix. Lost quite a few prints that way before I started using Netfabb.
Also, as Mongerdesigns said, check the location of your supports. One of those rings looks to have claw settings that extend right down the shank to a point that might generate overhangs when printed in that orientation.