Page 1 of 1

Vivitek WH1188 - how to turn of vivitek logo 'screensaver'

Posted: Mon May 20, 2019 9:24 am
by LarsZ
I've been using the Solus for some time now and I suddenly noticed there is a 'Vivitek' logo (=text 'Vivitek') 'burned' in my printing foil! I've gone trough the setting menu's of the beamer but could not find anything to turn this off. Also in windows 10 the settings for screensaver is set to 'none'. Also I don't know were this logo comes from as I always turn the beamer off before I turn the PC off....

Does anyone else also got this problem? Of perhaps even knows a solution?

Re: Vivitek WH1188 - how to turn of vivitek logo 'screensaver'

Posted: Tue May 21, 2019 1:08 am
by Jewelermdt
That square orange Plexiglas that came with your printer should Always be between your printer and projector lens until you start a print. The logo is programmed in the projector. Would have to look in the projector menu to see if you can turn it off.

Re: Vivitek WH1188 - how to turn of vivitek logo 'screensaver'

Posted: Wed May 22, 2019 7:11 am
by LarsZ
Jewelermdt wrote:That square orange Plexiglas that came with your printer should Always be between your printer and projector lens until you start a print. The logo is programmed in the projector. Would have to look in the projector menu to see if you can turn it off.

Thank you for your reply! I thought that it was just for calibration (to make the grid move visible). The orange sheet of plexiglas also has a paper attached to one side, I always kept it on as it kind of helped during calibration. Is this also the purpose of this paper or should it be removed? I'm kind of nervous of scratching either the projector lens or the window in the side of the printer.....

Re: Vivitek WH1188 - how to turn of vivitek logo 'screensaver'

Posted: Fri May 24, 2019 3:23 am
by Jewelermdt
it can stay on. You just want to block light from projector getting to the printer. The orange color of the Plexiglas adsorbs the UV light so as not to allow the resin to cure.

Re: Vivitek WH1188 - how to turn of vivitek logo 'screensaver'

Posted: Tue Jun 11, 2019 9:01 am
by LarsZ
I have been using the plexiglas square for a couple of weeks now and it works perfectly. :-) Thank you for the advise!