Dear Fellows!
Please help me to fix my issue!
During the printing a model something caused a failure and print process stopped.
The platform in low position now.
How I can set it to start position without damaging the crystal?
The vat is in its place and I can't remove.
Is there a method to lift up the platform easily?
Best regards,
Robert
During print failure platform is in low position
Re: During print failure platform is in low position
Do you have Creation Workshop installed? Whenever I have had this happen I close out of Contour, open Creation Workshop, connect to the printer, select the control tab, and click the arrow to move the Z axis up.
Re: During print failure platform is in low position
Sadly I don't have, I use Contour.
But will check!
Thanks for the response!!!
But will check!
Thanks for the response!!!
Re: During print failure platform is in low position
And what to do, if I don't have a CW? Any other solution? THX!
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: During print failure platform is in low position
Turn off power to the printer. Turn the screw by hand to raise it up.
Once high enough take off build plate. Power back on and do home cycle.
Once high enough take off build plate. Power back on and do home cycle.
Who is online
Users browsing this forum: No registered users and 78 guests