tilt switch problems?
Posted: Wed Aug 14, 2019 5:16 pm
red is screw, green is part of tilt plate, blue is broken plastic piece.
just got my replacement quartz and was going over the internals to find what screw had to be turned to make the homing more consistent when I found this broken plastic thing. Not sure what it is or what it's for.
In the picture the extruded bottom is fully broken from light touch. Before that, it was looking as in the diagram(blue part). I'm assuming that the dotted part should have been there, however I see no sign of it anywhere. All that was there is the solid blue shape. Seems like that could have been the cause of my intermittent homing problems in the past. :shrugs
Any guidance? Can I print out a replacement on my fdm or need I order it?
just got my replacement quartz and was going over the internals to find what screw had to be turned to make the homing more consistent when I found this broken plastic thing. Not sure what it is or what it's for.
In the picture the extruded bottom is fully broken from light touch. Before that, it was looking as in the diagram(blue part). I'm assuming that the dotted part should have been there, however I see no sign of it anywhere. All that was there is the solid blue shape. Seems like that could have been the cause of my intermittent homing problems in the past. :shrugs
Any guidance? Can I print out a replacement on my fdm or need I order it?