Print Not Attaching To Build Platform
Posted: Wed Aug 14, 2019 6:11 pm
Hello,
I've noticed that every once in a while on my prints (so not every time), the initial layers of my prints seem to not stick to the build platform. Instead, what happens is that the cured resin just sticks to the film immediately and every subsequent layer continues to be stuck there.
I'm curious if anyone else has encountered this problem? Also, are there any tips that I'm missing/forgetting for preparing/cleaning the build platform? Or should I just consider curing the initial layers for longer?
Thanks for any tips.
I've noticed that every once in a while on my prints (so not every time), the initial layers of my prints seem to not stick to the build platform. Instead, what happens is that the cured resin just sticks to the film immediately and every subsequent layer continues to be stuck there.
I'm curious if anyone else has encountered this problem? Also, are there any tips that I'm missing/forgetting for preparing/cleaning the build platform? Or should I just consider curing the initial layers for longer?
Thanks for any tips.