grid squished

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
Posts: 13
Joined: Wed Jun 27, 2018 7:43 pm

grid squished

Postby sprue » Tue Oct 22, 2019 9:41 pm

I recently did an update and afterwards was getting consistently bad prints. I checked to make sure everything was correct, updated contour, checked the projector settings, and double checked the graphics settings. I went through the entire setup over again and now I'm getting a squished grid projection. The dial is all the way over to the side so I can't enlarge it any bigger. Any ideas?
User avatar
Solus Guru
Posts: 1933
Joined: Sat Apr 25, 2015 5:16 pm
Location: Los Angeles

Re: grid squished

Postby mongerdesigns » Tue Oct 22, 2019 9:58 pm

Seems like the wrong aspect ratio is selected. Either in the projector menu or graphics card menu.

Check the resolution of the projector too to make sure it's on 1920x1080 pixels.
Monger Designs a.k.a. Monger

Junction3d - Official US Distributor for the SOLUS 3D PRINTER

Follow us on Instagram!

Who is online

Users browsing this forum: No registered users and 10 guests