Page 1 of 1

Problems with the Print

Posted: Wed Nov 27, 2019 3:23 am
by BasilL
Hi
I have been using my current Solus printer and projector for the past year. We had a problem start initially, but everything worked out and I was able to print good models with it.
We started having problems with the printer since the start of this month. I remember there was a computer update and the next time I print, there was terrible problems with the print job.
I have tried everything I know to do, including changing the resin, changing the film, recalibrating the printer, the grid, cleaning the lens, everything. But the print job still comes out really bad.
Attached are some of the images.
I would appreciate any help or suggestions. Thank you very much.

Re: Problems with the Print

Posted: Wed Nov 27, 2019 4:31 am
by Jewelermdt
After update did you check the RGB computer display settings. Make sure you check the projector settings. Most times an update reverts the setting back to default. Fairly certain that is your problem.