Page 2 of 2

Re: Print problem. What cause this issue?

Posted: Tue Jan 14, 2020 1:55 am
by mongerdesigns
rrobbie wrote:Ok, I found the original site. I missed, 4000 in normal mode.

https://www.infocus.com/products/sp-lamp-085

6000 hours in Eco mode...


Those are manufacturers hours. Nowhere near real world and also for 3d printing it last less. 1500 hours or so is about right.

Re: Print problem. What cause this issue?

Posted: Tue Jan 14, 2020 7:43 am
by rrobbie
Ok, thanks for the information.
It seems I have to order a new lamp...

Re: Print problem. What cause this issue?

Posted: Tue Jan 14, 2020 2:13 pm
by Mikkopee
rrobbie wrote:Ok, I found the original site. I missed, 4000 in normal mode.

https://www.infocus.com/products/sp-lamp-085

6000 hours in Eco mode...

Yes, but when you use it for PRINTING not watching movies it should be replaced after 1500h. UV is getting weaker.

E: Monger was first :D

Re: Print problem. What cause this issue?

Posted: Tue Jan 14, 2020 2:15 pm
by Mikkopee
rrobbie wrote:Ok, thanks for the information.
It seems I have to order a new lamp...

Make sure its ORIGINAL lamp. There can be some difficulties when using other than original.

Re: Print problem. What cause this issue?

Posted: Wed Jan 15, 2020 9:32 am
by rrobbie
Thanks for your help, I have ordered an original Osram bulb for it.