Solus Contour Pro
Posted: Sat Feb 20, 2021 4:31 pm
Solus Contour / Solus Contour Pro.
I´ve had the old Solus for some years and just got the new Pro with the Solus Contour Pro.
I usually draw my supports with Matrix 9 or used B9 Creator. Because at some point with the old Solus Creator it stopped showing the supports and sometimes I like to draw them instead using the generator.
It lifts the model up and colors the areas to be supported green, runs the Generating Supports but shows none. Only support I get is with a ring model, manual the base support.
Actually I can get the ring base under any model even divided in multiple parts.
Now with the new Pro it does the same, I have a laptop I used with the old Solus printer and Contour works fine on it, the new 0.24. So it must be something with my main PC that is causing this? I have updated the graphic driver (NVIDIA GeForce GTX 1060 6GB).
Mark Kuhnlein has been helping me and is doing a fine job, we are waiting for an answer from a software developer. Just wanted to ask if someone here has experienced anything similar.
Would be nice to be able to use the software that came with the machine, it looks good.
Thanks, Timo.
I´ve had the old Solus for some years and just got the new Pro with the Solus Contour Pro.
I usually draw my supports with Matrix 9 or used B9 Creator. Because at some point with the old Solus Creator it stopped showing the supports and sometimes I like to draw them instead using the generator.
It lifts the model up and colors the areas to be supported green, runs the Generating Supports but shows none. Only support I get is with a ring model, manual the base support.
Actually I can get the ring base under any model even divided in multiple parts.
Now with the new Pro it does the same, I have a laptop I used with the old Solus printer and Contour works fine on it, the new 0.24. So it must be something with my main PC that is causing this? I have updated the graphic driver (NVIDIA GeForce GTX 1060 6GB).
Mark Kuhnlein has been helping me and is doing a fine job, we are waiting for an answer from a software developer. Just wanted to ask if someone here has experienced anything similar.
Would be nice to be able to use the software that came with the machine, it looks good.
Thanks, Timo.