Every time I finish a print I have to unplug the usb from the printer and then plug it back in otherwise it doesn't see the arduino driver.
Is this necessary everytime?
Jeff
CW doesn't see driver
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: CW doesn't see driver
check your settings in control panel - device manager. Be sure the usb port is set to never go to sleep.
Should not have to unplug - re-plug.
Should not have to unplug - re-plug.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: CW doesn't see driver
Jeff, are you running on Windows 10?
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: CW doesn't see driver
running on Windows 7pro.
Who is online
Users browsing this forum: No registered users and 4 guests