Hey everyone!! Just sold this piece today!! I am happy about that! Any suggestions on how to start supporting this? I was thinking about a 25* tilt . It has lots of little over hangs so I think I will add some bridges to the model first. Then supports underneath. I have found that Tilt gives such a better finish. Thanks Mark
Supports question
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Supports question
Hi Mark,
Would have to look at the STL but seems simple enough. I don't think titling the model will add anything unless you have large horizontal areas to support.
Would have to look at the STL but seems simple enough. I don't think titling the model will add anything unless you have large horizontal areas to support.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 15 guests