Adjusting Gamma, Contrast, and Brightness

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
Post Reply
User avatar
3dLuke
Novice
Posts:22
Joined:Wed Jan 27, 2016 3:18 pm
Location:Minnesota
Contact:
Contact 3dLuke
Re: Adjusting Gamma, Contrast, and Brightness

Postby 3dLuke » Fri Feb 05, 2016 8:57 pm

Its quiet that's for sure. I really like the machine, its just getting my head wrapped around how it works. FYI I think I did have the Vat Film too tight because I watched the video tutorial again and adjusted a new film in the Vat and that sound went away.
Best Regards,

Luke Johnson
Senior Designer
Arthur's Jewelers Creations.
Other Custom Designs by Luke Johnson
Top
User avatar
Jewelermdt
Solus Master
Posts:809
Joined:Sun Jul 19, 2015 10:38 pm
Location:N.W. Florida
Contact:
Contact Jewelermdt

Re: Adjusting Gamma, Contrast, and Brightness

Postby Jewelermdt » Sat Feb 06, 2016 3:59 am

Luke
Check you setting in device manager so the the USB ports do NOT turn off or go idle on non use.
Top
User avatar
reify
Site Admin
Posts:571
Joined:Mon Mar 16, 2015 6:10 pm

Re: Adjusting Gamma, Contrast, and Brightness

Postby reify » Sat Feb 06, 2016 7:50 am

3dLuke wrote:Its quiet that's for sure. I really like the machine, its just getting my head wrapped around how it works. FYI I think I did have the Vat Film too tight because I watched the video tutorial again and adjusted a new film in the Vat and that sound went away.



The vat should only sit about 0.5mm above the printer before the thumbscrews are installed.
Top
Post Reply

Return to “Help and Troubleshooting”

Who is online

Users browsing this forum: No registered users and 84 guests