Hello,
I am using Emerald resing and haven't printed anything for a few days... When I went to set up a print I looked underneath the resin take and there is a white film collecting inside the resin. Is this normal? Is the resin inside the tank contaminated? Will this affect my print if I go forward with it? If it is a problem, how would i go about cleaning it out? I am not supposed to touch the inside film right? Any insight is appreciated, Thank You!
White film collecting in bottom of resin tank
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: White film collecting in bottom of resin tank
Maybe you can post a photo?
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: White film collecting in bottom of resin tank
Mixed it up the best I could and got as much of it off the bottom as I could. Went ahead with the print and it cam out... I will post a picture when it settles to the bottom again.
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: White film collecting in bottom of resin tank
I would think the white stuff is moisture getting in the tank somehow. If I clean a print in water and Dawn for to long it comes out with a white coating on the print.
Who is online
Users browsing this forum: No registered users and 78 guests